maytag bravos xl washer troubleshooting

15. September 2020 @ 14:19

Begin by cleaning the switch contact points on the lid and the body of the washer with a cotton swab dipped in rubbing alcohol to remove any dirt and lint build-up. I have unplugged it for 10 min and then was able to get it - Answered by a verified Appliance Technician. 04/23/2019 by rebeccasenn20. I came online and was told to pull the washer out from the wall, then tip the top back so I could get under it and remove the drain hose and see if something was pluging it. If the lid lock/switch assembly won't lock and unlock properly, replace it.If the washer is started several times without the lid ever being opened, then this code appears. It is perfectly normal for the machine to hum or buzz when it fills with water or is in the process of sensing the load size.

Use only HE (High Efficiency) detergent. If the inlet water valve assembly is defective, replace it. +1-888-873-3829. Use a level to verify the machine sits level and flat.Check for a coin, bobby pin or some other metallic object not removed from a clothing pocket if you hear clicking noises coming from the machine.

If you find that your clothes are still soaking wet after washing or hear a loud noise just before or after the spin cycle, inspect the clutch and replace if necessary.One of these parts is most likely the cause of your Maytag washer making loud noise when spinning, but unfortunately, not all washer repairs are cost-effective. The last thing you want is a broken drive motor or transmission, which is why the motor coupling connects the two and is designed to fail in case of overloading.This helps to prevent a much bigger repair, but it can also be noisy if you continue to use the washer once it fails.

If the issue is still there, unplug the washing machine, wait 1 minute and try again. The Maytag line has been around for more than one hundred years with the first washer introduced to the market in 1907.

To help you check the solenoid, water lines, and remove the unit for cleaning, consult the 2 Answers. Pay attention to the sounds the washing machine makes, so you can learn them. The fabric softener dispenser will not function properly and leaves gooey residue in the dispenser cup. Open the lid if the washer severally vibrates during spinning and redistribute the load.

View and Download Maytag BRAVOS XL use and care manual online. If the drain pump is defective, replace it.Water isn't being detected as entering the washer. Check the washer drain and the drain hose for clogs or restrictions. Also verify that the water hoses are not crimped, as this could affect the performance of the washer as well. Make sure that fill hoses are properly connected. If not, then a garment could be stuck between the outer tub and the spin basket. If the washer still doesn't fill, check the inlet hose screens where the water hoses attach to the washer. Excess lint is especially problematic if the HE washer is ever overloaded or if too much detergent is used. As one of the most often used appliances in the home, most likely there will come a time when a washer repair is necessary. If the drain path is clear, unplug the washer and check the drain pump. It should measure around 50K ohms (50,000 ohms) at 77 degrees. If the lid switch on the lid lock/switch assembly isn't detecting the condition of the washer lid properly, then the lid lock/switch assembly will need to be replaced.Unplug the washer. Open the console and check the resistance through the thermistor circuit (black wires). January 1 by Greg. If you have reasons to believe that this is just an error, press Pause/Cancel twice or Power once. Brenner graduated from San Diego's Coleman College. We use cookies to give you the best possible experience on our website. How to Remove Fabric Softener and Dryer Sheet Stains From Clothes The most common reason that a fabric softener dispenser is that the dispenser is clogged.

When "LF" is displayed, there could be an issue with the water flowing into the machine.